Custom Pommel Section 001 [for Clan saber series] diy such as Fisto

such as Fisto

I recommend a minimum of 25% infill to give it a good weight

This come weathered

This is an empty hilt but can be installed and uses a 7/8" blade and a 28mm speaker

as some printers struggle with that small curve

Custom Pommel Section 001 [for Clan saber series] diy such as FistoThis is a custom pommel made out of a series 1 body and a special series 2 end nut. It comes with an Oring. There are 3 versions: Sand blasted with polished nut and the all polished. All polished All polished with Bronze anodized aluminum body Note: These parts are compatible with the other Clan Saber Series. You can mix and match sections to create custom saber designs.