1.5" Steering Clamp Add Hardware:NO - I'LL SUPPLY MY OWN HARDWARE Designed to accept solid front

Designed to accept solid front and rear axles

2 x Steel Cap Retaining Rings for use when drive gear is not installed

The entire top bridge of our truss spans the full width of the axle

Use the best d-ring mounts on the planet - proudly manufactured in-house at TMR Customs

Looking to mount to a steel surface using magnets

1.5" Steering Clamp Add Hardware:NO - I'LL SUPPLY MY OWN HARDWARE Designed to accept solid frontTMR's Steering Clamp is THE answer if you are running a tie rod that measures 1. 5" diameter. Running a traditional steering stabilizer? Simply use the smaller 1 2" 20 tapped hole. Running a ram assist cylinder? Simply use the larger 5 8" 18 tapped hole. Since the clamp is tapped for both sizes it's modular allowing you to change your system in the future without the need to purchase a new clamp! Fits 1. 5" Diameter Tie Rods Tapped for both steering